|
Post by 420toker on Jan 14, 2010 13:18:01 GMT -5
I installed a new Amana dishwasher about 8 weeks ago. Everything has worked fine until yesterday. Suddenly, no water. It cycles completely through, but no water.
Water is coming up to and through the valve under the sink, so I'm ok up to there.
I'm going to try and fix it tomorrow. I'd appreciate some guidance as far as first check this, then this, etc. Thanks!
|
|
|
Post by mark on Jan 14, 2010 13:38:00 GMT -5
A simple check would be to check the float inside of the dishwasher, it may be stuck in the up position, which would cause no water to come in, Try to move the float up and down to check it, it should be in the down position.
|
|
|
Post by 420toker on Jan 15, 2010 7:46:37 GMT -5
ok the float does seem to be stuck. Can it be freed up or should it be replaced.
|
|
|
Post by applianceman on Jan 15, 2010 15:57:57 GMT -5
Well, since its only 8 weeks old, i would now suggest to call Amana to set up a free in-warranty service call, they will fix it for you.
|
|